Products

Through our precise manufacturing techniques, overseen by engineers with a tremendous commitment to quality, Voltarc produces Masonlite Millenium^TM Electrodes – the unrivaled choice for signage professionals worldwide.

At Voltarc we use the best raw materials, including shells deep drawn from the finest-quality, pure soft iron, and nickel plated in a custom-built, dedicated plant. The result is first-rate electrodes without the risk of contamination.

Our lead wires are made of standard nickel wire for corrosion-resistance and flexibility, along extra length of copper-clad Dumet sealed into the pinch to enhance confidence in the metal-to-glass seal, and solid-nickel wire for high purity and low outgassing, attached to the shell for reliability via a welding method pioneered by Masonlite. 



Masonlite Millennium™ Electrodes - Bombarding and Pumping Procedure
The following procedure is for 15/50C and 15/50CT electrodes on 15mm or larger diameter coated Sign Tubing. Adjust the procedure for other electrode sizes, smaller diameter tubing, and tubes less than 18" long.

Preheat

1. Open vacuum valve and evacuate tube to approximately 2 to 3 Torr (2 to 3 mm Hg) pressure. Close vacuum valve. 
2. Turn on bombarder and bring current to between 150 and 200 mA.
3. Continue bombarding until the tube reaches 275° to 300°F (135° to 150°C).  Always release bombarder switch prior  to opening of main stopcock. Then open vacuum valve. Evacuate tube(s) for 45 to 60 seconds, depending on tube length and configuration.

Step 2

1. Close vacuum valve, refill tube(s) with 2 to 3 Torr
   (2 to 3 microns) of dry air. 
2. Turn on bombarder and raise current to 325 mA;
   continue heating until tube reaches 375° to 400°F
   (190° to 205°C). Note:  for uncoated tubes, heat to
   482°F (250°C).  At this point reduce pressure to 1 Torr
   or slightly less. 

Step 3

1. Increase current to 800 mA.
2. Bring electrode shells to a bright, cherry-red color, (1,652° to 1,832°F (900° to 1,000°C)) while maintaining ½ to 1 Torr pressure. Once all shells are of a uniform color, release the bombarder switch and open the vacuum valve. 
3. Evacuate the tube(s) to the lowest possible pressure - at least 3 to 5 millitorr (3-5 microns).  Continue pumping until you can comfortably handle the tube(s) - about 122 °F (50°C).
4. Release accumulated moisture in the tabulation(s) at this time with the aid of a heat gun or hand torch. This prevents transfer of moisture to the finished tube(s) during flushing and/or backfilling of the inert gas(es).
5. Backfill the tube(s) to the designated pressure with the desired gas using a positive pressure gauge if possible.

Masonlite Millennium^TM Electrodes
Lead Glass Electrodes: Mica Disc - Ceramic Collar - Premium Steel Shell